SEARCH


FM STATIONS
Products


TX08KSS PLUG-IN NEXT GENERATION

COD. TX08KSS/60D43/EPS

Power: 8.000W

TX08KSS PLUG-IN NEXT GENERATION

8.000W PLUG-IN Next Gen System.

FEATURES

• Tunable over entire FM band (87.5 – 108 MHZ), without tuning.

• Overall efficiency better than 71-73%.

• Hot-pluggable and broadband power amplifier modules.

• High redundancy guaranteed.

• Each amplifier module provides Automatic Power Control.

• Each module has its own hot plug-in fans set.

• Suitable for mono & stereo broadcast operations.

• Protection against high VSWR, overdrive, overcurrent and overtemperature.

• Compliance to IEC safety standards.

• Compliance to ETSI – CCIR – FCC standards.

• Entire transmitter can be switched off through an emergency button.

• All measurement and working parameters are displayed on front panel.

• Remotely controllable by telemetry system.

• Design for 24/7 non-stop operation.

• The transmitter include an integrated system for automatic and manual switching between two exciters.
In Automatic mode the changeover is activated when active power of exciter falls below 3dB.



EPS:

 Each power supply “PS" can be removed or plugged without turning off the transmitter.

• The transmitter is capable of generating an output power with ample margin thanks to oversized power supplies.

• By installing an additional PS, the transmitter will operate at full power in the event of a single PS failure, eliminating the need for derating.

• Each PS features an automatic magnetic switch preventing short circuits and ensuring uninterrupted signal broadcasting.

• The power stream generated by these PS are distributed in parallel to all RF modules; consequently if one
power supply fails all RF modules maintain balanced operation.

• The transmitter’s CCU oversee continuously the operational status of each individual power supply.

• In the event of a failure the "ECM" electronic control module will optimize the transmitter efficiency.

• In an empty slot an  additional power supply can be turned on so in the
event of a power supply failure there will be no reduction in power. It is  a N+1 PLS system . Only from 4 to 10kW(option)



TX08KSS/60D43/EPS
Parameter Value
GENERALS
RF Output Power 8kW + 10%
Frequency Range 87,5 – 108 MHz
Driver power for rated output 30W
VSWR 1.4:1 with automatic fold-back at higher VSWR
Asynchronous AM S/N Ratio Typically >70dB
Synchronous AM S/N Ratio Typically > 55dB
Harmonics suppression and Spurious Typically <85db
RF Harmonics Exceeds ETSI/CCIR/FCC requirements
RF Spurious Exceeds ETSI/CCIR/FCC requirements
Environmental working conditions -10 °C to + 50 °C / 95% relative Humidity non condensing
POWER REQUIREMENTS
AC Power Input AC Supply Voltage 400V ±10% AC Three-Phase 3F+N
230V ±10% AC Three-Phase 3F+N
230V ±10% AC Mono-Phase 50/60 Hz
Active Power Consuption about 11.100W
Power factor > 0.95
Overall Efficiency 71/73 %
Connector Terminal Block Standard
MECHANICAL DIMENSIONS
Phisical Dimensions L x H x W 40u: 685 mm x 1935 mm x 1000 mm 
32u: 685 mm x 1620 mm x 1000 mm                                                             
Weight about 290 kg
Cooling Forced, with internal fan
Acoustic Noise <75 dba
OUTPUTS
RF Output 50 Ohm (1+5/8" EIA flange type)




ORDERING INFORMATION

  • TX08KSS PLUG-IN NEXT GENERATION
    8.000W PLUG-IN Next Gen System.
  • TX08KSS/00D43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + 2x BLUES30NV).
  • TX08KSS/01D43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + 2x TEX30LCD/S).
  • TX08KSS/20D43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + 2x PTX30LCD/S).
  • TX08KSS/41D43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + 2x PTX30LCDDSP).
  • TX08KSS/60D43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + 2x PTX30DDS).
  • TX08KSS/00S43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + BLUES30NV).
  • TX08KSS/01S43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + TEX30LCD/S).
  • TX08KSS/20S43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + PTX30LCD/S).
  • TX08KSS/41S43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + PTX30LCDDSP).
  • TX08KSS/60S43/EPS
    Plug-in next gen transmitter, 8kW (composed of PJ8KPS-CA + PTX30DDS).

OPTIONS

  • /N+1 PSL
    OPT. An additional power supply can be turned on so in the event of a power supply failure there will be no reduction in power




Download the General Catalog

SUBSCRIBE TO OUR NEWSLETTER

Receive all the news and promotions