PJ60KPS-CA

COD. PJ60KPS-CA

Power: 60.000W

60.000W PLUG-IN System.

The image of this layout is purely demonstrative and may change without notice. The configuration is only referred to installed equipment; rack, cover panels and all others accessories are to be defined at order.

FEATURES

Tunable over entire FM band (87.5 – 108 MHZ), without tuning.
Overall efficiency better than 72-74%.
Hot-pluggable and broadband power amplifier modules.
Each module features switching mode power supply to control and stabilize power supply voltage.
Each amplifier module provides Automatic Power Control.
Suitable for mono & stereo broadcast operations.
Protection against high VSWR, overdrive, overcurrent and overtemperature.
Compliance to IEC safety standards.
Compliance to ETSI – CCIR – FCC standards.
Entire transmitter can be switched off through an emergency button.
High redundancy guaranteed by 16 power modules of 2.5 kW RF power.
All measurement and working parameters are displayed on front panel.
Remotely controllable by telemetry system.
Design for 24/7 non-stop operation.
24 free units available for additional equipment.
The air outlet is available on the top of the transmitter using steel pipes.

PJ60KPS-CA
Parameter	U.M.	Value	Notes
GENERALS
RF Output Power	kW	65
Frequency Range	MHz	87,5 – 108
Frequency Stability	ppm	± 1
Class of Emission		180KF8E Direct to Channel
Stereo transmissions		Ace to ITU-R / Ree 450 (Pilot tone)
RF Output Impedance		50 Ω
RF Output Connector		4-7/2” EIA Flange (4-1/2” EIA Flange on request)
VSWR		1.4:1 with automatic fold-back at higher VSWR
Asynchronous AM S/N Ratio	dB	Typically >70
Synchronous AM S/N Ratio	dB	Typically > 55dB
Harmonics suppression and Spurious	dB	Typically < 85dB
Overall efficiency	%	Typically > 72-74
RF Harmonics		Exceeds ETSI/CCIR/FCC requirements
RF Spurious		Exceeds ETSI/CCIR/FCC requirements

DOCUMENTS

ORDERING INFORMATION

 PJ60KPS-CA
60.000W PLUG-IN System.